Skip to main content
BrewMarkBREWMARK

Kafatek · Dial-in guide

Kafatek Monolith Conical grind settings

Why there is no single number for the Kafatek Monolith Conical, and how to find a starting point on your own unit instead.

Kafatek Monolith Conical
AdjustmentStepless
CollarUnmarked
BurrsConical
Published settingNone

Why there is no setting here

The Monolith Conical adjusts on a stepless collar with no standardised marking, and each grinder is hand-built and calibrated individually. A rotation count from one unit does not transfer to another, so there is no number one owner can read off and another can copy.

We used to print one anyway: the same placeholder curve as the Flat Max, entered when the catalog was built and never read off a real dial. When a Flat Max owner showed us how far off that curve was, we stopped publishing it for both Monoliths rather than keep a number we cannot stand behind.

Dialing in from your own reference point

Starting guidance from owners, not a specification. Sour or weak means go finer; bitter or harsh means go coarser.

  1. 01Find your own zero. With the grinder empty, close the burrs slowly until you hear them just begin to touch, then stop — never force them together, and follow Kafatek’s own instructions for your version.
  2. 02Mark that point on the collar with a pencil line or a piece of tape. That mark is your reference, and it only means something on your grinder.
  3. 03Count rotations open from the mark, in whatever fractions your own indicator shows, and write down where each coffee lands.
  4. 04For espresso, owners report starting about half a rotation open from zero, then going coarser by taste and shot time.
  5. 05For pour over, expect a couple of rotations open, and let taste rather than a number decide where you stop.

If you own a Monolith Conical and keep notes on where your coffees land, tell us which version you have and what you found. One unit’s reading is not a chart, but several might show us what does and does not transfer.

Dialing in the Monolith Conical

A hand-built boutique single-dose grinder with a long waiting list and a devoted following. Conical burrs give it a heavier, more textured cup than the flat Monoliths. Its collar is stepless and unmarked, and each unit is calibrated individually, so we no longer publish a setting for it: dial in from a zero point you mark on your own grinder.

Corrections to this page

  • 2026-10-21The Monolith pages no longer give a number. Kafatek has changed the dial and thread between versions, and the collar is unmarked, so no figure holds across units. The pages now explain how to dial in from your own zero point.
Every correction, with what the page said before →

Own a Monolith Conical? Tell us your setting

If you’ve dialled in a method on your own Monolith Conical, the number you landed on is the best evidence there is. Readings are checked by hand before anything changes here.

← All grinder charts